Applications
- Single Board History Module
- Dual Logical WDA History Module
- Single WDA History Module
Solid State Technology …
These CompactFlash based solid state drives emulate the original Winchester hard drives used in Honeywell’s WDA History Module with dual-logical(ST318438LW) and single(ST32272N) and (ST3600N) drives (3½” Seagate drives) and the Single Board History Module (various 2½” laptop drives)
Easy Installation …
With the same form factor as the original drive and matching connectors, these replacement drives install easily in place of the original hard drive. For a redundant installation, the new drive can then be synchronized with an original drive, following the same procedure as with the original hard drive. For a non-redundant installation, the new drive may be restored from a backup of your current configuration.
Single board history module drives can be replaced with the SBHMCF formatted as a 1.8GB dual logical drive. The CFHDD is the solid state replacement for both the 1.8GB and 875MB WDA dual Logical drives. Single WDA applications can be upgraded using the CFHDS solid state replacement formatted for either 1.8GB, 875MB, or 445MB. WDA drive trays can be purchased separately as needed. Solid State drives can only be mounted on drive tray 51403393-100.
Low Maintenance …
The solid-state design of these replacements and a lack of moving parts results in disk replacements which are highly reliable and are not subject to bearing wear, head crashes, or other mechanical failure.
Notes …
You must be running at least rel 5xx in order to upgrade to this dual logical configuration. The hardware revision of the SPC board must be minimum rev D, and the firmware revision of the SPC board must be revision J.